Modifying an HS-311 Servo for Continuous Rotation
Connect the servo to your microcontroller (here an Arduino) and tell it to move to position 0 (i.e., a pulse width of 1500µs). The gears should start spinning, unless it was previously at 0.
10,629
views
0
faves
6
comments
Uploaded on June 11, 2008
Taken on June 11, 2008
Modifying an HS-311 Servo for Continuous Rotation
Connect the servo to your microcontroller (here an Arduino) and tell it to move to position 0 (i.e., a pulse width of 1500µs). The gears should start spinning, unless it was previously at 0.
10,629
views
0
faves
6
comments
Uploaded on June 11, 2008
Taken on June 11, 2008