new icn messageflickr-free-ic3d pan white
Radiator grill fitting | by Sabrebuilder
Back to photostream

Radiator grill fitting

I then glued a length of rubber hose with PU18 adhesive to the cowl. The hose is just a gap filler to attach the grill to. (Note: I later discovered the PU18 softened the black 'schultz' coating my painter put on the inside of the cowl so I had to redo this stage after removing the schultz to get a good bond with the GRP. A messy job with white spirit but no harm was done)

69 views
0 faves
0 comments
Uploaded on March 1, 2020