new icn messageflickr-free-ic3d pan white
Radiator cowl trim | by Sabrebuilder
Back to photostream

Radiator cowl trim

I first fitted the chrome/plastic trim. This comes with an adhesive bead inside that is supposed to stop it coming off. On the day I fitted it, it was very cold in my garage so I put the trim in the tumble drier for a while to warm it up and make it easier to form round the bends. Plastic trim has a tendency to shrink over time so I cut the trim about 3mm oversize and then forced the last section in so that the joint is under compression.

92 views
0 faves
0 comments
Uploaded on March 1, 2020