new icn messageflickr-free-ic3d pan white
Servo 7 - Electrical | by Nick Ames
Back to photostream

Servo 7 - Electrical

Cut the wires at the potentiometer, then heat their pads and remove them. Remove the solder from the middle pad with solder wick. Apply flux, then heat the left pad and push a resistor into it. Heat the right pad and push a resistor into it. Apply flux and solder the two resistors to the middle pad.

 

www.fetchmodus.org/projects/servo/

3,990 views
0 faves
0 comments
Uploaded on July 11, 2012