new icn messageflickr-free-ic3d pan white
1:72 Rostov Tilt Rotor Aircraft Company РТАК-30 (NATO ASCC code “Hemlock”); 3rd prototype "33 Yellow" during state acceptance trials; Zhukovsky (Moscow Oblast), 1987 (Whif/kitbashing) - WiP | by Dizzyfugu
Back to photostream

1:72 Rostov Tilt Rotor Aircraft Company РТАК-30 (NATO ASCC code “Hemlock”); 3rd prototype "33 Yellow" during state acceptance trials; Zhukovsky (Moscow Oblast), 1987 (Whif/kitbashing) - WiP

Painting and markings:

With such an exotic aircraft, I rather wanted a conservative livery and opted for a typical Soviet tactical four-tone scheme from the Eighties – the idea was to build a prototype aircraft from the state acceptance trials period, not a flashy demonstrator. The scheme and the (guesstimated) colors were transferred from a Soviet air force MiG-21bis of that era, and it consists of a reddish light brown (Humbrol 119, Light Earth), a light, yellowish green (Humbrol 159, Khaki Drab), a bluish dark green (Humbrol 195, Dark Satin Green, a.k.a. RAL 6020 Chromdioxidgrün) and a dark brown (Humbrol 170, Brown Bess). For the undersides’ typical bluish grey I chose Humbrol 145 (FS 35237, Gray Blue), which is slightly lighter and less greenish than the typical Soviet tones. A light black ink wash was applied and some light post-shading was done in order to create panels that are structurally not there, augmented by some pencil lines.

 

The cockpit became light blue (Humbrol 89), with medium gray dashboard and consoles. The ejection seats received bright yellow seatbelts and bright blue pads – a detail seen on a Mi-28 cockpit picture.

Some dielectric fairings like the fin tip were painted in bright medium green (Humbrol 101), while some other antenna fairings were painted in pale yellow (Humbrol 71).

The landing gear struts and the interior of the wells became Aluminum Metalic (Humbrol 56), the wheels dark green discs (Humbrol 30).

 

The decals were puzzled together from various sources, including some Begemot sheets. Most of the stencils came from the Ka-52 OOB sheet, and generic decal sheet material was used to mark the walkways or the rotor tips and leading edges.

 

Only some light weathering was done to the leading edges of the wings, and then the kit was sealed with matt acrylic varnish.

 

1,321 views
3 faves
3 comments
Taken on March 28, 2019