new icn messageflickr-free-ic3d pan white
3-D Jack O' Lantern 2011 (3/5) | by mr.origami
Back to photostream

3-D Jack O' Lantern 2011 (3/5)

Artist: Daniel Brown

The finished model! Laying flat on its back, with a ruler for scale. He ended up 15" (38 cm) high, which is actually larger than most carved pumpkins.

After this photo, I tried to set him up on his base, but the weight of the paper was too much for the single-layered lower jaw portion. So, he ended up getting some minor internal support structures installed - don't hold it against him. Out of tissue foil (or on a smaller scale,) he holds together just fine.

1 fave
1 comment
Taken on October 5, 2011