new icn messageflickr-free-ic3d pan white
KN13 Pulsar SE - Wiring & ECUs 11 | by 3ndymion!!!
Back to photostream

KN13 Pulsar SE - Wiring & ECUs 11

Fun, FUN... no, not really actually. This is what I had to do to be able to use this thing. I had to remove each & every single wire from the plugs & use them with no plugs. If I remember right, I had to search for special, smaller connectors to fit the very small pins that are in this ECU, because the USDM ECU & wiring used big, clunky pins & connectors. I managed to find them from an online electronics store, though they were very hard to find back then. I put a connector on each wire & covered it with heat shrink so they don't touch each other & blow everything up.

69 views
0 faves
0 comments
Taken on March 5, 2006