new icn messageflickr-free-ic3d pan white
MILS MultiRoad Parking Example 2 | by Ludo Soete
Back to photostream

MILS MultiRoad Parking Example 2

This is a combination of the MILS MultiRoad Laneway entrance, some parking lot modules and some parlor modules around it.. Building instructions can be found here (except the parlor modules):


The Parking entry sign is a custom printed white 2x4 tile. Mounting it on the pole was a bit tricky. I cut 2 grey Technic Half pin ( 4274) and glued it in the grey tile 1x1 with clips (2555 or similar). An alternative could be cutting the THIN ring from the Plate 1 x 1 with clip Light Type 1 (4081) and use both studs on the thin ring to assemble without glue.

6 faves
1 comment
Taken on February 27, 2006