Good Circuit Boards Require Good Clamping #3

Board on left full of burr's due to poor clamping which results in

vibration and burrs. Board on right made with better clamping through

use of fender washers.

Laen and EverydayInventors faved this
  • Jeff Saltzman PRO 4y

    Wow such a huge improvement, congratulations!
  • 2fic 4y

    definitely nice net result for the extra $4!
  • John_NY_LMR 4y

    Wow! Nice result. I've had 2 mills that produced the circuit board on the left. I can't wait to try proper clamping.
  • Mikey Sklar PRO 4y

    John_NY_LMR Good clamping helps a lot. I find these two steps help a lot:

    1. Put the bit shaft deep into the chuck to reduce wobble.

    2. Consider doing multiple passes @ 1 mil increments. Deep cuts create lots of issues.
1,789 views
2 faves
4 comments
Taken on May 6, 2011
  • Casio EX-Z16
  • ƒ/2.9
  • 6.3 mm
  • 1/125
  • 200
  • Flash (off, did not fire)
  • Show EXIF

Additional info

  • Viewing this photo Public
  • Safety level of this photo Safe
  • S Search
    Photo navigation
    < > Thumbnail navigation
    Z Zoom
    B Back to context