PennLUG Landing Plate 1

When I first started the "evolved" series, I was hoping to turn it into something bigger than just a few MOCs. This is the first step.

 

It's obviously based on the Classic Space landing pad, but is not 100% accurate. The circle should almost touch the dashed lines and the radius should be a bit smaller. The studded areas on the side should be bigger and there are two yellow stripes missing. And lastly the little arrows should be small dashes but I couldn't make it work.

 

But I figured it was a good jumping off point. It's set up to be compatible with the PennLUG road standard, but sits on 48 x 48 instead of the usual 32 stud baseplate.

5,329 views
31 faves
22 comments
Uploaded on January 19, 2011