|
tonious' photostream |
|
Desktop CNC Design
This is the first iteration of my desktop CNC. The design has only a passing relationship to reality -- nevertheless, it is available on github.
All rights reserved
Uploaded on Jul 4, 2011
Stepper motor mount.
Stepper mount and barrier strip.
Acrylic stepper motor mount, and Red Green calibre barrier strip.
All rights reserved
Uploaded on Jul 4, 2011
Nut with setscrew.
At each end, the leadscrew is held snug into a skateboard bearing with a nut and setscrew.
All rights reserved
Uploaded on Jul 4, 2011
Y-Axis
At last! A more-or-less complete axis! The lead screw is 5/6" allthread. It's close enough to an...
All rights reserved
Uploaded on Jul 4, 2011
Small scale success!
While hardware store drill rod may not work for simple slide bearings, it works just fine with these skateboard bearing based chucks
All rights reserved
Uploaded on Jul 4, 2011
Bearing Jig
Here's a chunk of delrin beveled to have two 45 degree angles. This and some skateboard bearings should work.
All rights reserved
Uploaded on Jul 4, 2011
Slide Bearings
The bearings fit into the body quite nicely, however they didn't slide! Hardware store drill rod isn't...
All rights reserved
Uploaded on Jul 4, 2011
Match drilling bearings.
The idea here was to drill out delrin slide bearings and MDF brackets to hold rods at the same time in the hope that they'd be parallel.
All rights reserved
Uploaded on Jul 4, 2011
The box.
Little does this humble plywood box know, it will someday become a CNC router.
All rights reserved
Uploaded on Jul 4, 2011
The Office
Desktop CNC
Valentines Card 2010
The Crowie
Little Robots
Arc Reactor
Gr8 Designs for Gr8 Girls...
Screenshots and Visualizations
