|
tiltnraise's photostream |
|
www.tiltnraise.com-mount04
Here is N3DCJ lining up the mount with the receiver hitch.
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount10
Here is the mount tilted to one side, the rag is used to keep from chipping the powder coating. Powdercoating is chip resistant but is not chip proof.
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount08
Removing the stainless steel wing nuts for the support tube.
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount05
www.tiltnraise.com-mount03
The Tilt-N-Raise portable antenna mount. This mount is suitable for EmComm and portable operations such as special events and Field Day.
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount18
And then there is the stainless wing nuts. Notice that the installation requires no tools!
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount19
The completed installation of the Tilt-N-Raise portabel antenna mount. More pictures available at our web site: www.tiltnraise.com.
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount17
Replacing the stainless u-bolt for the vertical support tube.
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount16
Walking the antenna support mast and antenna up into place. Notice the ease with which the antenna goes up?
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount14
Lining up the base of the A99 antenna with the support tube. Observant radio operators...
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount15
Sliding the A99 antenna all the way into the vertical support tube.
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount13
www.tiltnraise.com-mount11
Here is a shot of the antenna mast being inserted into the vertical support tube.
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount12
Sliding the support mast into the vertical support tube, the OD of the support mast is 2".
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount09
Sliding the stainless u-bolt off of the vertical support tube.
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount07
www.tiltnraise.com-mount06
Starting the lock pin through the receiver hitch and the Tilt-N-Raise antenna mount.
All rights reserved
Uploaded on Feb 19, 2010
www.tiltnraise.com-mount02
This is the antenna support mast (not included in purchase) and the A99 vertical antenna used for the demonstration.
All rights reserved
Uploaded on Feb 19, 2010
Installation Clips
