|
strider_mt2k's photostream |
|
15) Rear arm stop fitting
A piece of the same scrap that makes up the motor mounts is bolted to one corner of the motor to...
All rights reserved
Uploaded on May 7, 2011
16) Rear arm stop fitting, motor wired
12) Removable battery mockup and balance testing
This mockup has the battery holder set in place using nylon wire ties. Lamps were assembled for this...
All rights reserved
Uploaded on May 7, 2011
13) Removable battery mockup and balance testing
battery was inserted into the battery holder and Aziz was run using an external 12 volt battery to...
All rights reserved
Uploaded on May 7, 2011
14) Removable battery mockup and balance testing
7) Arm re-attach, front arm stop and switch install
9) Closeup of drive assembly with front arm stop installed
5) Lamp bases attached
2) Early Base W/Lamps Mockup
