|
sheekgeek's photostream
|
|
Just under the clouds looking at the launch area
Weather Balloon hardware
The perfboard shows an Arduino, GOS using, 3 axis accelerometer and a SD card reader. Three additional...
All rights reserved
Uploaded on Nov 20, 2011
Ozone sensor test
I placed the Ozone sensor in a pastic bag with a running DC motor and graphed the results.
All rights reserved
Uploaded on Nov 20, 2011
Inside payload box
The mylar was applied to the foam, then that side was used to make the inside of the box.
All rights reserved
Uploaded on Nov 20, 2011
Finished weather Balloon Payload Box
The finished weather balloon payload with the Ozone, Air Quality and barometric pressure sensors on the outside.
All rights reserved
Uploaded on Nov 20, 2011
Applying Mylar to Foam Core board
Mylar blankets were applied to black FoamCore board using a spray adhesive.
All rights reserved
Uploaded on Nov 20, 2011
Insulating Foam
Stuffing the payload boxes just before launch
At the very last minute, we opened the HotHands packs and turned on all the electronics
All rights reserved
Uploaded on Nov 20, 2011
First Weather Balloon
Bugfest 2010
How to Make a Swarm of WASP...
Repticon - Charlotte...
Rocketry of Central...
CPCC GeekFest 2009
Rocketry of Central...
Astronomy Days 2008
BugFest 2008
Geek Fest 2008
» More Sets
