sgstair's photostream  

More PCBs courtesy of Laen's aggregation service :) I got a whole two orders back today! that's a new...

All rights reserved

Uploaded on Feb 23, 2012

0 comments

Yet another side project; A while back I designed PCBs for a relatively simple persistence of vision top;...

All rights reserved

Uploaded on Feb 23, 2012

0 comments

Yet another side project; A while back I designed PCBs for a relatively simple persistence of vision top;...

All rights reserved

Uploaded on Feb 23, 2012

0 comments

This is definitely more exciting to me than anyone else, I'm sure This is the first motor control using...

All rights reserved

Uploaded on Feb 19, 2012

0 comments

cnc2 board with fixes! Well, fixes only applied to first two motor blocks, for testing. These are pretty...

All rights reserved

Uploaded on Feb 19, 2012

6 notes / 0 comments

A few more steps towards a usable system! * Programmed FPGA to blink LEDs (the most important thing in...

All rights reserved

Uploaded on Feb 12, 2012

1 comment

A bit better, now that all the connectors are in place. Next up: smoke test & getting the software...

All rights reserved

Uploaded on Feb 7, 2012

0 comments

Reflow = easy mode. And this CNC board is significantly less painful to assemble than the previous one.

All rights reserved

Uploaded on Feb 7, 2012

2 comments

I got a fever, and the only perscription is... more boards :) Yes, yes really. This will be fun.

All rights reserved

Uploaded on Feb 6, 2012

0 comments

XMOS Board with fixes. This board has given me the most trouble of any in the recent past... Most boards...

All rights reserved

Uploaded on Jan 28, 2012

3 notes / 1 comment

Reflow! All the things!

All rights reserved

Uploaded on Jan 25, 2012

2 comments

New Crucial 64GB 6gbps SSD based on Marvell controller. I got this drive to replace a database drive...

All rights reserved

Uploaded on Jan 20, 2012

0 comments

New Crucial 64GB 6gbps SSD based on Marvell controller. I got this drive to replace a database drive...

All rights reserved

Uploaded on Jan 20, 2012

0 comments

Yet more boards! Laen has apparently got some shiny purple mailers to go with the shiny purple boards...

All rights reserved

Uploaded on Jan 18, 2012

4 comments

In case anyone asks what I do for fun, the answer is: This. After prodding at the first CNC board for...

All rights reserved

Uploaded on Jan 16, 2012

6 notes / 2 comments

All rights reserved

Uploaded on Jan 15, 2012

0 comments

Hey look, it's that board again! This time there are some subtle differences: * 16MHz crystal instead of...

All rights reserved

Uploaded on Jan 8, 2012

0 comments

Mmmmm, pcbs :) (Hard to be unhappy with so much purple & gold)

All rights reserved

Uploaded on Jan 5, 2012

0 comments