|
SCX_Tyler's photostream |
|
Kyra on the desk
I had planned on clearing my entire desk, cleaning it and moving my computer to the other side since...
All rights reserved
Uploaded on Dec 23, 2009
Kyra on the desk
I had planned on clearing my entire desk, cleaning it and moving my computer to the other side since...
All rights reserved
Uploaded on Dec 23, 2009
positioning the rad
Positioning the rad to make sure all of the holes line up before I start cutting.
All rights reserved
Uploaded on Dec 22, 2009
positioning the rad 2
Positioning the rad to make sure all of the holes line up before I start cutting.
All rights reserved
Uploaded on Dec 22, 2009
Case prepped
I have removed or taped every painted surface on the case to make sure it does not get scratched.
All rights reserved
Uploaded on Dec 22, 2009
Template
I had problems with my printer and rather than waiting until the morning to get it printed I taped a...
All rights reserved
Uploaded on Dec 22, 2009
Template 2
Last corner
Cutting the last corner with the dremel, most of the cutting was done with a hacksaw blade but the...
All rights reserved
Uploaded on Dec 22, 2009
First watercooling setup installed
Mounted the rad and mobo with few problems, spent hours figuring out how the tubing should be run in...
All rights reserved
Uploaded on Dec 22, 2009
Nearly everything installed
Just need to put on the front panel, all of the cables and side panels and hard drives back into the hot swap bay.
All rights reserved
Uploaded on Dec 22, 2009
Computer
Toronto Olympic torch relay
Niagra Falls trip 246...
