rgdaniel's photostream  

TV Stand - FINAL

This is (hopefully) the last of at least 7 design iterations in Sketchup for the TV stand I've been mulling over for several months now... Version 6 was actually marked final and the cutting had begun, when I realized that the shelves it included would not be necessary and would in fact unacceptably reduce the available space for components.

The main pieces were already cut based on version 6 of the plan, which had a full-thickness back, stopping short of the top and bottom (for ventilation). This would have involved a ridiculous amount of wood trim to cover exposed particle board, more than anywhere else on the project... It didn't make sense to put all that effort into trimming out the least-visible part of the thing.

So here I went with 1/4-inch hardboard for the back, full-coverage, with ventilation holes and wire-access holes, top and bottom.

Exposed edges will all be trimmed out with solid walnut, with the top and bottom receiving a full inch-wide treatment, giving them the illusion of being thicker, and differentiating them from the upright pieces (sides and divider). The base will be mitered, all going well…

We'll see if this plan holds through the whole build...

All rights reserved

Uploaded on Nov 29, 2009

4 comments