Untitled

Anyone can see this photo Attribution Some rights reserved

Uploaded on Jan 25, 2012

2 comments

Untitled

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 23, 2011

1 comment

Untitled

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 18, 2011

1 comment

Untitled

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 10, 2011

0 comments

Untitled

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 10, 2011

0 comments

Untitled

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 10, 2011

0 comments

Untitled

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 10, 2011

0 comments

Untitled

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 8, 2011

2 comments

Untitled

9.5" inches of verawood. 1.5" pommel on one end and a beveled hammer for ultimate leverage.

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 8, 2011

4 comments

Speeder Bike WIP

Speeder Bike WIP

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 7, 2011

0 comments

Speeder Bike WIP

Speeder Bike WIP

Critiques?

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 7, 2011

1 note / 4 comments

Untitled

And then close that shit.

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 7, 2011

0 comments

Sad Drawer is happy again!

Sad Drawer is happy again!

Now you can stand back and look upon your completed project in awe. You are a man. You fucking did it!

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 7, 2011

1 note / 0 comments

Almost there!

Almost there!

After that all was left was the riveting. If you've never used a rivet gun before; well go fuck yourself....

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 7, 2011

3 comments

Hammer time!

Hammer time!

Using the ball peen hammer I bent down each piece on the half inch marks I made. Make sure it's good and uneven like in the picture.

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 7, 2011

0 comments

Meaure your tabs!

Meaure your tabs!

After the rectangles were cut out I used the square again to mark out a half inch on one side of each...

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 7, 2011

0 comments

A piece of metal!

A piece of metal!

I found a piece of metal laying around the garage, and used very precise measurements to cut out the...

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 7, 2011

0 comments

Tools Needed

Tools Needed

The tools I used were: -cordless drill (and bits) -rivet gun (and rivets) -square -sharpie -tin snips Not Shown: -bench vice -ball peen hammer

Anyone can see this photo Attribution Some rights reserved

Uploaded on Dec 7, 2011

0 comments

← prev 1 2 3 4 5 6 7 ... 127 128
(2,303 items)
Subscribe to a feed of stuff on this page... Subscribe to Repoort's photostream – Latest | geoFeed | KML