|
Dave Rollinson's photostream
|
|
Castle Ring, near Rugeley
View from atop Castle Ring, over looking Rugeley Power Station
All rights reserved
Uploaded on Dec 1, 2011
Barry White On One Inbred
On One Inbred - 14" It's finished in the Barry White paint job, which is a flecked metallic black...
All rights reserved
Uploaded on Sep 22, 2010
My Inbred
20" frame and built as a single speed. Have the Pace RC31 Rigid carbon and titanium fork. It's a...
All rights reserved
Uploaded on Sep 22, 2010
New Horizons Cropped
Made in Photoshop. Just messing around a bit. Cropped top and bottom of original.
All rights reserved
Uploaded on Sep 15, 2010
Pace hardtail
The bar now cut down, and all controls fitted
This is the bar reduced to my liking. Remember that you must take into consideration bar ends (if you are going to fit them) BEFORE you cut the bar!
All rights reserved
Uploaded on Feb 21, 2010
Carbon bar with alloy insert fitted
You can see that the fit is nice and snug. Use a rubber or soft mallet to help you fit into the bar if needs be.
All rights reserved
Uploaded on Feb 21, 2010
Sizing up
This bar is huge - it's off my full susser and I always thought it too wide. Time to cut it down me...
All rights reserved
Uploaded on Feb 21, 2010
Alloy tube
I cut a one inch or so length to make the inserts. As long as it's wider than the bar ends clamp and...
All rights reserved
Uploaded on Feb 21, 2010
Rough edges...
Obviously, I need to deburr and file/sand the piece before I put it inside the handle bar. Take your time with this - you don't want a bar failure!
All rights reserved
Uploaded on Feb 21, 2010
Cut to length
I have now cut the handle bar to my desired length, taking into consideration the width of my bar end...
All rights reserved
Uploaded on Feb 21, 2010
Gently does it...
The insert is now square in the bar. It has been cleaned up prior to fitting and I used a rubber mallet...
All rights reserved
Uploaded on Feb 21, 2010
Marked up and ready to SAW
I have used some masking tape here to help me follow the line I need to saw. I measured in from the bar...
All rights reserved
Uploaded on Feb 21, 2010
Hope pad retaining pin improv
Probably a tad too big, but if it comes off next ride I'll make a new one a bit smaller.
All rights reserved
Uploaded on Feb 21, 2010
Hope pad retaining pin improv
I took a paper clip and and bent it as follows with some long nose pliers. Just need to cut to length and fit - easy peasy!
All rights reserved
Uploaded on Feb 21, 2010
Cannock Chase
Trimming a carbon handle...
Landscapes
Misc
Bikes
