Michael Kat's photostream

Soldered the male headers and female sockets into the breakout board. Good way to practice soldering.

All rights reserved

Uploaded on Dec 17, 2009

0 comments

Set up the arduino feedback light. The other radio used a headphone jack as output.

All rights reserved

Uploaded on Dec 17, 2009

0 comments

Set up of the arduino doorbell.

All rights reserved

Uploaded on Dec 17, 2009

0 comments

Configuring the xbee and downloaded the xbee config and selected a pan id, the ATID, ATMY and ATDL....

All rights reserved

Uploaded on Dec 17, 2009

0 comments

Removed the servo and replaced it with a headphone jack. Connected one wire to ground and the other to...

All rights reserved

Uploaded on Nov 15, 2009

0 comments

Connected the potentiometer to power/ground and to Arduino pin 0. Hooked up the servo motor...

All rights reserved

Uploaded on Nov 15, 2009

0 comments

Connected power and ground wires of the motor and potentiometer to the breadboard. Added the TIP 120...

All rights reserved

Uploaded on Nov 15, 2009

0 comments

Upgraded by adding a switch and an H Bridge that will control the direction. The Tom Igoe pin diagram...

All rights reserved

Uploaded on Nov 15, 2009

0 comments

Connected the potentiometer to the arduino and breadboard (red wire to power, black to ground, middle to analog pin 0)

All rights reserved

Uploaded on Nov 15, 2009

0 comments

Uploaded the code to arduino board and turned the potentiometer to reveal the ASCII values

All rights reserved

Uploaded on Nov 15, 2009

0 comments

Uploaded the Sensor Graphing Sketch in Processing and turned the potentiometer to watch the graph rise and fall.

All rights reserved

Uploaded on Nov 15, 2009

0 comments

Using the multimeter tested to see if the wires are electronically connected.

All rights reserved

Uploaded on Oct 1, 2009

0 comments

After tinning, heated both components but it took some time before the solder was hot enough to join...

All rights reserved

Uploaded on Oct 1, 2009

0 comments

Created a custom switch, using household items. The lucky cat has foil underneath and the cardboard...

All rights reserved

Uploaded on Oct 1, 2009

0 comments

Created a custom switch, using household items. The lucky cat has foil underneath and the cardboard...

All rights reserved

Uploaded on Oct 1, 2009

0 comments

Verified and uploaded the code to my board. Changed the delay to 50 to make it blink rapidly.

All rights reserved

Uploaded on Oct 1, 2009

0 comments

Verified and uploaded the code to my board. Changed the delay to 50 to make it blink rapidly.

All rights reserved

Uploaded on Oct 1, 2009

0 comments

Tested 3 different states on the arduino. Button 3A Verified and uploaded the code to my board. The...

All rights reserved

Uploaded on Oct 1, 2009

0 comments