|
ChrisTC7045's photostream |
|
How to get it all in one garage
Part finished body sitting on top of dexion platform - more space would make it much easier.
All rights reserved
Uploaded on May 2, 2008
Front axle mounting
From the top: rebound plate, cage bolts, axle mounting flange, back end of link pin bracket, spring plate, spreader plates then locknuts
All rights reserved
Uploaded on May 2, 2008
Link pin bracket front
Getting the link pin out was tricksy - needed heavy vise well padded to stop the pin rotating while you attempt to take the nut off.
All rights reserved
Uploaded on May 2, 2008
Rebound rubber - front
brakepipe union
engine earth will connect to the bolt on top of the bracket
All rights reserved
Uploaded on Apr 25, 2008
handbrake cable
brake pedal shaft
Brake master cylinder not yet installed. Loosely assembled since it will have to be dismantled to allow the fume exclusion rubber to be fitted.
All rights reserved
Uploaded on Apr 24, 2008
rear end awaiting axle
front end rebuild
Course of remote handbrake grease point
