|
markgosling's photostream |
|
As found
I found this on my desk after returning from one of the other offices.
All rights reserved
Uploaded on Feb 2, 2008
The start of the proccess
It works!
The first board etched drilled and assembled. As you may be able to read this was a gift for a...
All rights reserved
Uploaded on Jan 4, 2008
The (almost) finished article
Etching
Almost done. For some reason the bubbles decided to only come out of the first half after a while.
All rights reserved
Uploaded on Jan 4, 2008
Lid!
PCB hanger
Two cable ties on a bamboo skewer. I heated the end's of the cable tie's so they would point up.
All rights reserved
Uploaded on Jan 4, 2008
Bubble
Add an aquarium heater. I 'modified' mine to get it up to a fish killing fifty degrees centigrade. I...
All rights reserved
Uploaded on Jan 4, 2008
Glue
Glue it all together and and hold in place. (then do the washing up) I used ordinary silicon sealant...
All rights reserved
Uploaded on Jan 4, 2008
3x A4 6mm Perspex
Maplin used to sell and etch tank for a very reasonable £20. Now they don't :-( So get yourself some Perspex and make one!
All rights reserved
Uploaded on Jan 4, 2008
Cut
Cut two, two inch strips for the sides and they left over is for the base.
All rights reserved
Uploaded on Jan 4, 2008
