TuxRug's photostream

This is the page linked to by the scam mail. It's a grammar nightmare. They can't even stick to one...

Some rights reserved

Uploaded on Nov 27, 2009

10 notes / 0 comments

I received two copies of this email to the same address. Notice it is littered with grammar errors. ...

Some rights reserved

Uploaded on Nov 27, 2009

5 notes / 1 comment

I built this quite a while before the floppy pen box was featured on Lifehacker. I use it to hold...

Some rights reserved

Uploaded on Jul 27, 2008

1 comment

Ha-ha, nice try, script-kiddie!

Some rights reserved

Uploaded on Jun 17, 2007

5 notes / 2 comments

OOH a shocker! First attempt, no tripod, had to run a perspective filter on the wallpaper (took a...

Some rights reserved

Uploaded on Jun 14, 2007

0 comments

Finished!

Some rights reserved

Uploaded on Jan 29, 2006

10 comments

Test-fit your iPod. Adjust the swively things.

Some rights reserved

Uploaded on Jan 29, 2006

0 comments

Now the hard part: Without letting the connector fall or push off the wedges, place the 3-layer bar where shown.

Some rights reserved

Uploaded on Jan 29, 2006

0 comments

Place the connector between the wedges. Make sure the dock connector icon is facing the front of the dock.

Some rights reserved

Uploaded on Jan 29, 2006

0 comments

Slide in the connector from behind.

Some rights reserved

Uploaded on Jan 29, 2006

0 comments

The connector. If you did all this only to discover you did'nt have a connector, you are a moron.

Some rights reserved

Uploaded on Jan 29, 2006

0 comments

Add the third half-height layer to the front bar.

Some rights reserved

Uploaded on Jan 29, 2006

0 comments

Stick a layer of half-height bricks on top of the 6x1 half-height brick.

Some rights reserved

Uploaded on Jan 29, 2006

1 comment

Now to make the front bar.

Some rights reserved

Uploaded on Jan 29, 2006

0 comments

Place the swively things centered on the back of the back bar.

Some rights reserved

Uploaded on Jan 29, 2006

0 comments

Put the swively things together with 2x1 half-height smooth-top bricks.

Some rights reserved

Uploaded on Jan 29, 2006

0 comments

2x6 half-height brick in back to connect the back wedges. This is the back bar.

Some rights reserved

Uploaded on Jan 29, 2006

1 comment

Put the sides on each side of the connector-angle-stabilizing wedge assemblies. Make sure the wedges are pointing inward.

Some rights reserved

Uploaded on Jan 29, 2006

0 comments