Attlebridge's photostream

All of the completed handmade components for my Big Sister doll costume. I hope you found my...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

4. Place the soaked garment on the towel, spread mostly flat. 5. Firmly press the used tea bag against...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

Let's make this bodysuit look old! 1a. Gather a large bowl, a full kettle of water, and a bag of...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

My first air tank looked wicked awesome, but it was very heavy and the magnets kept failing, so I...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

6. Turn the next finger right-side-out; do only one at a time, as to not get them mixed up! 7. Clip the...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

1. I sewed 2 tubes of vinyl and cut holes for the thumbs to go through. Right now they look like...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

"Would you care for some EVE?"

All rights reserved

Uploaded on Feb 10, 2012

0 comments

1. I referenced the lengths needed by holding up the remaining brass strips to the brace plates strapped...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

1. Base coat the pieces with metallic paint (spray paint or acrylic works best). Allow the paint to fully...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

9. As one option for the syringes, I'm trying plastic tubing. I coloured metallic pipe cleaners with...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

8. Lay out the hardware, to make sure everything is there. Reinforce the back of the gauntlet with a...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

6. Referencing the gauntlet, mark on the strip where the bolts need to go (between the belts), and mark...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

1. Cut the copper sheet into 0.5" wide strips. Take one strip and mark the center (0.25"). Use...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

1. I put 4 belts on the top plate and 3 on the lower plate. Mark the center of the inside of the plates...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

1. Make the shape out of card paper. Hold the piece up to the doll and make sure it's the right...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

I started on the gauntlets and the leg braces. They were tough to plan out, so I settled for a slightly...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

Now it's time to finish the corset and make the shorts. I want to have as little bulk as possible when...

All rights reserved

Uploaded on Feb 10, 2012

0 comments

I started on the bodysuit and corset. The armor had to fit snugly over these two pieces, so I started...

All rights reserved

Uploaded on Feb 10, 2012

0 comments