Kegbot's photostream

We finally hooked a dollar bill acceptor ("tip jar") up to the Kegbot, and it actually works...

All rights reserved

Uploaded on May 13, 2010

0 comments

Here is our RFID-sensing Kegbot drip tray. An overview and full instructions for this can be found at the...

All rights reserved

Uploaded on May 13, 2010

0 comments

This is a bare version of Kegboard v2. We have dozens of these lying around; we had planned to sell kits,...

All rights reserved

Uploaded on May 12, 2010

0 comments

This was our second 'Kegboard', the Kegbot controller board. We received the boards the night before...

All rights reserved

Uploaded on May 12, 2010

0 comments

A very primitive monitoring system sent alerts to the phone. This was used primarily for system failures...

All rights reserved

Uploaded on May 12, 2010

0 comments

This is the original UI Kegbot used for pours. The progress bar rolls over every 8 ounces.

All rights reserved

Uploaded on May 12, 2010

0 comments

An iButton key is attached to the original Kegbot chest freezer.

All rights reserved

Uploaded on May 12, 2010

0 comments

Our original fittings and conversion hardware for the Kegbot. The flowmeter was threaded directly into a solenoid valve.

All rights reserved

Uploaded on May 12, 2010

0 comments

Debugging our first PIC.

All rights reserved

Uploaded on May 12, 2010

0 comments

This PIC16-based breadboard served as the original Kegbot controller board. It consisted of the PIC, a...

All rights reserved

Uploaded on May 12, 2010

0 comments