|
Graham.Browne's photostream |
|
DSC04358
the finished cradle with new male 30 pin connector from a cablejive extender. the original circuit...
All rights reserved
Uploaded on Jun 14, 2011
DSC04357
using epoxy to mount the 30 pin connector to the cradle
All rights reserved
Uploaded on Jun 14, 2011
DSC04355
DSC04354
new aluminum trim made from material picked up at lowes
All rights reserved
Uploaded on Jun 14, 2011
DSC04353
the finished speaker grill with cloth glued to speaker mount
All rights reserved
Uploaded on Jun 14, 2011
DSC04352
new grill material cut out from fender guitar amplifier cloth
All rights reserved
Uploaded on Jun 14, 2011
DSC04351
flat black paint was applied to the speaker mount to reduce glare from behind the grill cloth
All rights reserved
Uploaded on Jun 14, 2011
DSC04350
additional holes were drilled in the speaker mount to allow the new speakers to do their job
All rights reserved
Uploaded on Jun 14, 2011
DSC04349
darlington transistor setup allows the LEDs in the display to be driven from the original power LED on the klipsch circuit board
All rights reserved
Uploaded on Jun 14, 2011
DSC04348
DSC04347
this shows the original power switch wired to the dock. It was later swapped for a custom momentary...
All rights reserved
Uploaded on Jun 14, 2011
DSC04344
a new display window was cut with a dremel from acrylic sheet
All rights reserved
Uploaded on Jun 14, 2011
DSC04343
wiring with 3.5mm stereo jack to utilize RCA inputs as a auxiliary audio input
All rights reserved
Uploaded on Jun 14, 2011
graphic design/artwork
Vintage ipod dock
Wallmount PC
Grahamer Jammer
