|
Matt King's photostream |
|
In the room (unfinished)
Here they are, complete except for applying the finish.
All rights reserved
Uploaded on Jun 12, 2009
Construction Complete
Howie asists with load testing. I ended up going with aluminum angle irons to hold 3/4 in plywood as a base for the matress.
All rights reserved
Uploaded on Jun 11, 2009
A bitty bed!
One bed with the brackets installed. Maker included to give scale.
All rights reserved
Uploaded on May 28, 2009
Mortising a side rail
Mortising a headboard
Here's the jig I used to mortise out room for the knockdown hardware that joins the side boards to the head and foot boards.
All rights reserved
Uploaded on May 21, 2009
Rounding the edges
Lots of work on the router table tonight rounding over the edges of all the end pieces.
All rights reserved
Uploaded on Apr 30, 2009
Bitty Footboard
Rails after planing
All the rails had been passed across the jointer to flatten one face and then run through the planer to make...
All rights reserved
Uploaded on Mar 5, 2009
Mortising the posts
Working on mortising the posts. Unfortunately there wasn't time to do them all so I'll have to reset the machine next week.
All rights reserved
Uploaded on Mar 5, 2009
Milling the posts
What started as an 10' long 8/4 raw board turned into these 8 posts. Note for future projects: make sure...
All rights reserved
Uploaded on Feb 26, 2009
My first turned ornament
Took a wood turning class at the The Eliot School in Jamaica Plain. Here is the result, a small walnut...
All rights reserved
Uploaded on Oct 19, 2008
Jewelery Pin Board
Saw this idea in a magazine (which one?) and thought it was a good DIY idea. The base is a 1/4 in hardboard...
All rights reserved
Uploaded on Oct 21, 2007
Chinatown Parade
Itty bitty beds
Credenza
Mr Monkey
