gimbler's photostream  

Just another view, and not a very clear one. I carried it upstairs and hated the 48" height in the...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

Here it is finished, and it took less than 5 hours from start to finish and that included pausing to take...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

This is upside down and I added the bottom shelf a good distance from what will be the floor when I flip...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

View from under the shelves. You can fill these with the little Kreg plugs, wood filler, or just paint...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

The back side at the same stage. All the predrilled pocket holes now have screws in them and it feels...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

This is what it looks like flipped right side up at this stage with the end panels connected to the shelf...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

Making sure you've clamped it level screw the shelves to the side panels.

All rights reserved

Uploaded on Mar 5, 2012

0 comments

This is a view of the underside of the table top and the underside of the shelf.

All rights reserved

Uploaded on Mar 5, 2012

0 comments

Clamp the back board (with all the holes) to the top panel and screw it into the top. Make sure the top...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

These are the predrilled pocket holes on the back and the underside of the two shelves. See how the two...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

Close up of what I was just talking about.

All rights reserved

Uploaded on Mar 5, 2012

0 comments

This is the board in the back of the shelf. I didn't measure where I put these pocket holes, just...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

I painted before I drilled, cut or assembled anything. Just easier to do touch ups when it's finished.

All rights reserved

Uploaded on Mar 5, 2012

0 comments

I used Valspar Latex Enamel in Satin Black. I only did one coat and didn't prime or seal. This table...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

I lightly sanded each board - just enough so that it doesn't give me splinters! I love these little...

All rights reserved

Uploaded on Mar 5, 2012

0 comments

5 boards - all the same size: 1x12x48. They were about 6 bucks each at Lowes.

All rights reserved

Uploaded on Mar 5, 2012

0 comments

All rights reserved

Uploaded on Aug 31, 2011

0 comments

All rights reserved

Uploaded on Aug 31, 2011

0 comments