|
deegeeguy's photostream
|
|
mast-headsail attachment
mast-spreader detail close
the main mast spreader and supports (the big holes in the middle of the mast
All rights reserved
Uploaded on Sep 18, 2011
mast-main spreader and stay detail
mast-topspreader detail
mast - top windvane detail
windvane on top of read backstay. Note the radio antenna holder.
All rights reserved
Uploaded on Sep 18, 2011
mast-pulleydetail
the mast pulley and feeding line through before assembly
All rights reserved
Uploaded on Sep 18, 2011
portside
portside view - note new block needed. Only requires light sanding and varnishing to launch. All...
All rights reserved
Uploaded on Aug 11, 2011
rearhatch
Rear hatch needs varnishing and the working solar ventilation fittings attached.
All rights reserved
Uploaded on Aug 11, 2011
maststep
mast step has been scraped along with front of cabin. Requires sanding and varnishing/painting. Front hatch similar - requires varnishing
All rights reserved
Uploaded on Aug 11, 2011
starboardcockpit
cockpit requires some work. Starboard side needs under seating supports replaced.
All rights reserved
Uploaded on Aug 11, 2011
sternlookingforward
port side cockpit is going to require a new seat board and perhaps some support work. one sheet of 3/4 inch ply will do the entire cockpit
All rights reserved
Uploaded on Aug 11, 2011
stern
rear deck scraped and ready for sanding and painting/varnishing. The back cleat...
All rights reserved
Uploaded on Aug 11, 2011
transom
transom is pretty much done except for varnishing and painting boat names
All rights reserved
Uploaded on Aug 11, 2011
starboardhull
starboard side - again is caulked ready for a light sanding and varnishing.
All rights reserved
Uploaded on Aug 11, 2011
belowtostern
below decks looking out the door to cockpit. Stove area (single burner gimbal) is on the right in...
All rights reserved
Uploaded on Aug 11, 2011
below
cabin from door looking in. Needs some cleaning but that's about all
All rights reserved
Uploaded on Aug 11, 2011
cockpit
cockpit - as I said above, its going to require a sheet of plywood and some glue to redo the...
All rights reserved
Uploaded on Aug 11, 2011
