|
EntityLabs' photostream |
|
The finished indoor garden
Putting the drip system together
Sorry about my ugly foot, but this is a picture of the drip system almost complete. After this I put it in...
All rights reserved
Uploaded on Dec 13, 2009
A old T-shirt turned filter
Here I used a rubber band to keep the T-shirt filter on the bottle.
All rights reserved
Uploaded on Dec 13, 2009
just a shot of the work in progress
just a shot of the work in progress
just a shot of the work in progress
The hot glue job i did on the bottles
I used ample hot glue to keep the bottles attached. I've had it up three months, seems to hold just fine.
All rights reserved
Uploaded on Dec 13, 2009
just a shot of the work in progress
My ball robot
Where the axle attatches to the outer hull
deep inside the ball robot
With this inside shot you can see the batteries, accelerometer (green balck square thing) and the red arduino on the side
All rights reserved
Uploaded on Dec 13, 2009
DSC00053
Here is another shot of the inside - the switch is to keep the batteries from draining while idle... i...
All rights reserved
Uploaded on Dec 13, 2009
Another shot of the mess inside
You can see the accelerometer, arduino, and the two servos are on the left and right side.
All rights reserved
Uploaded on Dec 13, 2009
ball robot
the wires coming off are charging wires for the battery.
All rights reserved
Uploaded on Dec 13, 2009
Maker Fair 2007
San Fransisco
Cellphone pictures
