|
dhpeterson's photostream |
|
IMG_2302
IMG_2300
Place the carbon mat into the mould and start rolling it out to soak it from below.
Some rights reserved
Uploaded on Apr 25, 2010
IMG_2297
IMG_2296
Ron explaining the apparent and actual grain and tensile properties of the carbon mat
Some rights reserved
Uploaded on Apr 25, 2010
IMG_2295
Wet out the new layer of CSM underneath then lay the carbon into the mould
Some rights reserved
Uploaded on Apr 25, 2010
IMG_2289
Trimming off is best done when the glass is still green and tacky but before it goes completely hard.
Some rights reserved
Uploaded on Apr 25, 2010
Composites course
171 photos
10 views
Flight to Tambar Springs
10 photos
4 views
RV Builder Workshop
19 photos
68 views
