|
charlie.little's photostream |
|
Manifold8
Duct tape is used to cover/seal the inner ring and can foam insulation is shot into the voids...
All rights reserved
Uploaded on Apr 6, 2008
Manifold7
After drilling outer manifold holes, the manifold is assembled by placing the bottom manifold half...
All rights reserved
Uploaded on Apr 6, 2008
Manifold5
Some top leg anchors temporarily bolted and tightened. Outer anchor holes are aligned...
All rights reserved
Uploaded on Apr 6, 2008
Manifold4
16 pieces ( top leg anchors) of 1 1/2 inch thinwall steel tubing, 6 inches length each are cut and...
All rights reserved
Uploaded on Apr 6, 2008
Manifold3
Both halves are clamped together for drilling of 1/4 inch holes on every line, exactly 1in from the...
All rights reserved
Uploaded on Apr 6, 2008
Manifold2
After the first manifold half was made, another was traced and cut out identical. These are the two manifold halves.
All rights reserved
Uploaded on Apr 6, 2008
Manifold1
This is half of the manifold. It was cut out of a used 2ft. diameter aluminum stop sign after...
All rights reserved
Uploaded on Apr 6, 2008
DomeSideView
This is the first drawing of the imagined dome greenhouse frame.
All rights reserved
Uploaded on Apr 6, 2008
DomeManifold
This is the first drawing of the imagined Dome Manifold. A center hub for the top of a newly...
All rights reserved
Uploaded on Apr 6, 2008
Hydroponic Experiments...
Tomatoes started...one on left is in perlite only with foam plug. One on right is in a styrofoam...
All rights reserved
Uploaded on Mar 15, 2008
Hydroponic Fence Project Back End
This is where the excess from the drip feed line will spray into the horizontal return line.
All rights reserved
Uploaded on Mar 12, 2008
New Dome Greenhouse
