|
bkrpr's photostream |
|
Traditional book stand
Stant v2 foot attachment
The feet are attached to the body with an angle bracket. The outside edge of the foot and the body are...
Some rights reserved
Uploaded on Jul 24, 2009
Stand v2, side view
The supports are just two triangular feet attached by angle brackets.
Some rights reserved
Uploaded on Jul 24, 2009
Traditional stand with large book
This is what www.flickr.com/photos/bkrpr/3753 022344/ looks like with a large book on it. Notice how there is no way for the book to lay flat.
Some rights reserved
Uploaded on Jul 24, 2009
Stand v2, front view
New version of the book ripper stand. This is two separate pieces that pull apart to accomodate wide books.
Some rights reserved
Uploaded on Jul 24, 2009
Stand v2, angles
This is the stand flipped upside down, legs on top. The board that makes up the body of the stand has been...
Some rights reserved
Uploaded on Jul 24, 2009
Stand v2, angles
This is the stand flipped upside down, legs on top. The board that makes up the body of the stand has been...
Some rights reserved
Uploaded on Jul 24, 2009
Stant v2 foot attachment
The feet are attached to the body with an angle bracket. The outside edge of the foot and the body are...
Some rights reserved
Uploaded on Jul 24, 2009
Stand v2 support strap
If the two parts of the stand are pulling apart wen the book is in them, or you want to keep the the spine...
Some rights reserved
Uploaded on Jul 24, 2009
Stand v2 with support strap, top view
Here is the supporting strap holding the ripper against a large book. In this pic the strap is not really...
Some rights reserved
Uploaded on Jul 24, 2009
Stand v2 with support strap, front view
Here is the supporting strap holding the ripper against a large book. In this pic the strap is not really...
Some rights reserved
Uploaded on Jul 24, 2009
Stand v2 with large book
Here is what www.flickr.com/photos/bkrpr/3752 222995/ looks like with the same large book as...
Some rights reserved
Uploaded on Jul 24, 2009
Mount v2, plexi gripping point
Notice the spacer abetween the two large washers. This keeps the washers gripping the plexi evenly rather...
Some rights reserved
Uploaded on Jul 24, 2009
Mount v2
This second version of the camera-to-plexiglass mount uses the screw and a nut to grip the plexi between...
Some rights reserved
Uploaded on Jul 24, 2009
Mount v2, leveling arm
A little arm has been attached to the main mounting screw to help counterbalance any side-to-side tilt...
Some rights reserved
Uploaded on Jul 24, 2009
Mount v2, leveling arm attachment
Stand v1
Stand v2
Camera Mount v2
Example results
Camera Mount
Book ripper 1.0
