|
bionictechnophobe's photostream
|
|
Whistle
Cupcake with acceleration (3G 5D shield, Pololu drivers and RobG's acceleration branch firmware) 70mm/sec. 0.2mm layer height.
Some rights reserved
Uploaded on Feb 25, 2012
|
Map
Cupcake 3G 5D + acceleration
Thank you RobG! 70mm/sec feed, 80mm/sec travel. First test print. Using...
Some rights reserved
Uploaded on Feb 25, 2012
Smooth Minifig
After disabling the "monitor temperature during builds preference" in ReplicatorG.
Some rights reserved
Uploaded on Feb 12, 2012
|
Map
Bumpy minifig
Minifig printed on a MakerBot Cupcake. The printer paused several times during the...
Some rights reserved
Uploaded on Feb 12, 2012
|
Map
My Towel
Finally build my first RC plane - a Brooklyn Aerodrome Towel.
Some rights reserved
Uploaded on Feb 6, 2012
|
Map
