new icn messageflickr-free-ic3d pan white
DIY Light Tent Build (5 of 8) | by absencesix
Back to photostream

DIY Light Tent Build (5 of 8)

View DIY Light Tent Build (5 of 8) on Black

 

View DIY Light Tent Build (5 of 8) Map/EXIF

 

Canon PowerShot G12 + 6.1-30.5 mm @ 6.1 mm - 1/13 sec at f/4.0, ISO 1600

Unknown mode @ 0 EV E.C - Pattern metering - no flash

Subject Distance: 600 mm

 

Next, begin to cut your paper to size. I started by cutting 3 sheets 2 inches longer than the depth of the box. Since my banner roll was wider than the box, I then began by taping the sheet along one corner, and then cutting off the excess. Try to leave 1/2 inch along the edge of the box, so you have some room to put tape.

 

Your finished product should look like this.

 

Full instructions here.

 

47°34'56.23" N 122°1'49.59" W, 137 m

Kitchen Table, My Apartment

Sammamish, Washington, USA

 

Taken on 03.23.2011, uploaded on 03.26.2011.

 

©2011 Adam James Steenwyk. Please contact me at ajamess [at] gmail [dot] com if you would like to use this photo. Blog: www.f128.info

1,241 views
0 faves
0 comments
Taken on March 23, 2011