|
Aud1073cH's photostream |
|
Back of the DIY Lampshade softbox
Here is the DIY Lampshade Softbox mounted on a light stand with a standard umbrella clamp. The 3/8...
All rights reserved
Uploaded on Jun 15, 2011
DIY Lampshade Softbox angle
Here is a side view. A little light spills out of the back, but it doesn't bother me. I could use...
All rights reserved
Uploaded on Jun 15, 2011
"Bob" using DIY Lampshade Softbox
The setup for the DIY Lampshade Softbox test photos
The light source on the right, and a piece of black cloth on the left to...
All rights reserved
Uploaded on Jun 15, 2011
Lampshade Softbox ready to go
Here is the trimmed diffuser and lampshade soft box. I think I used 16 pieces of Velcro each side. I...
All rights reserved
Uploaded on Jun 15, 2011
DIY Lampshade Softbox mounting system
I wanted some simple way to mount the softbox. I figured out a system to go into the umbrella clamp. ...
All rights reserved
Uploaded on Jun 15, 2011
DIY Lampshade Softbox materials
I wanted a softbox that was simple and cheap to construct. But I also wanted it to look halfway decent....
All rights reserved
Uploaded on Jun 15, 2011
The face of the DIY Lampshade Softbox
Seems fairly even to me, perhaps a little shadow in the bottom. I suppose some diffusion right on the...
All rights reserved
Uploaded on Jun 15, 2011
DIY Lampshade Softbox diffuser
I spread the shirt out on the table and traced the shade using a felt pen. I cut out a circle about...
All rights reserved
Uploaded on Jun 15, 2011
"Bob" without softbox
Without the softbox. Sharp cast shadows on the surface, across the teeth, and in the eye sockets.
All rights reserved
Uploaded on Jun 15, 2011
Christmas Bucket 2010
Last Christmas I wrapped 10 strings of LED lights around a foam core and put them in a clean white...
All rights reserved
Uploaded on Feb 4, 2011
Banana Patch Cables
I'm planning on building a little suitcase noise synth. I know that I'll want to start making noise as...
All rights reserved
Uploaded on Aug 28, 2010
DI box II - input side
I had a second enclosure, so I decided to make a second DI box. This one I used rocker switches and a...
All rights reserved
Uploaded on Aug 28, 2010
DI box II - output side
I had a second enclosure, so I decided to make a second DI box. This one I used rocker switches and a...
All rights reserved
Uploaded on Aug 28, 2010
DI box II - wiring inside
Here is the DI box wired up. A little snug, but the short wire lengths should help reduce noise.
All rights reserved
Uploaded on Aug 28, 2010
DI box II - parts
Here I've assembled the parts for the DI box. I've already cut the holes for switches, input and...
All rights reserved
Uploaded on Aug 28, 2010
Banana Patch Cables
I'm planning on building a little suitcase noise synth. I know that I'll want to start making noise as...
All rights reserved
Uploaded on Aug 28, 2010
Mī-DI (open)
Say: "My D-I" Clockwise from left: 1/4in. input, transformer, XLR output, phase flip switch, -30dB pad switch and ground lift switch.
All rights reserved
Uploaded on Jun 8, 2010
