|
CPS II's photostream |
|
Finished 1
And there we have it. A fully functional Pro Controller with the added functionality of the analog rotary encoder for Tempest 2000.
All rights reserved
Uploaded on Apr 8, 2007
Soldering complete
All wiring has been finished. The ribbon cable and row of connectors that were removed have been...
All rights reserved
Uploaded on Apr 8, 2007
Re-fitting the boards
You can see that the boards fit nicely around the encoder.
All rights reserved
Uploaded on Apr 8, 2007
Bridging complete
All the traces and connectors that were cut have now been bypassed and are ready to be bridged.
All rights reserved
Uploaded on Apr 8, 2007
Encoder spindle top
It also happens to be directly beneath and in line with the Atari logo. Nice.
All rights reserved
Uploaded on Apr 8, 2007
Encoder spindle
I positioned the encoder so it would be as near to the d-pad as possible without overlapping...
All rights reserved
Uploaded on Apr 8, 2007
Encoder fitted
This is the tiny rotary encoder that I used for this project. I have drilled a hole in the front of the pad case and set the encoder in epoxy resin.
All rights reserved
Uploaded on Apr 8, 2007
After being cut.
Here you can see the enlarged gap which I've cut at the top of the board. You can also see that the...
All rights reserved
Uploaded on Apr 8, 2007
De-soldered.
Ribbon cables de-soldered from top board. The 'notch' at the top of the board will have to...
All rights reserved
Uploaded on Apr 8, 2007
