|
Phillippy's photostream |
|
Axis 1
Pictures of axis 1 assembled, with the end of travel sensor's on the carriage. This operates very well on a 9 volt battery.
All rights reserved
Uploaded on May 29, 2008
100_1175
Axis 1 assembled close up to show End of travel bumpers on the carriage.
All rights reserved
Uploaded on May 29, 2008
100_1174
My controller with an extra button to initiate the code programmed into my PICAXE.
All rights reserved
Uploaded on May 29, 2008
100_1172
a different shot, it shows the back of my "SERIAL" comm- board.
All rights reserved
Uploaded on May 29, 2008
bigbird2
100_0879
Demo of my estimated "capacity" 14x14 inches, so a Surface area of 196"
All rights reserved
Uploaded on Apr 22, 2008
100_0878
100_0876
100_0875
Ok, so this is kindof a cheat progress shot, the only thing bolted down is that metal bracket from a fax machine.
All rights reserved
Uploaded on Apr 22, 2008
100_0874
Demoing what I did to the printer "skeltons" I used a Dremel & ground off most protusion's except the main "base.
All rights reserved
Uploaded on Apr 22, 2008
100_0873
This is the "skeleton" of the fax machine, it had less big protrusion's, but alot of small...
All rights reserved
Uploaded on Apr 22, 2008
100_0872
Detail shot of the fax machine's skeleton & the curve I cut. I will take more pictures tomorow...
All rights reserved
Uploaded on Apr 22, 2008
CircigamiCrane
This is a rough draft of a "circigami" crane. If you fold on the blue lines...
All rights reserved
Uploaded on Mar 19, 2008
Kit01
Master bedroom 1
