barnoid's photostream  

Shot from the Pervasive Media Studio at Watershed over about an hour and three quarters. Watch out for the hen party loading onto the blue barge before it speeds off.

It was shot through a 3-stop neutral density filter at f22 to allow for half-second exposures on this sunny afternoon.

Bristol Hackspace ran an Arduino workshop. This is a panning timelapse of the first day's morning session. I reversed the direction halfway through by reprogramming the panner's Arduino.

This is my Honeywell HIH-6130 breakout board populated with components. I tested it and it works perfectly. I only made one, this is a composite photo to show the front and back.

Actually my second, I didn't realise until I was about to start soldering that the first was mirrored and so couldn't work with the surface mount chip.

It's a breakout board for a Honeywell HIH-6130 humidity and temperature sensor. I designed the layout in Eagle, printed it out and transfered some toner onto the copper board by pressing the print against it and heating with an iron. This didn't transfer enough toner though so I went over it with a pen.