lmaurits' photostream

One of the 3W LED "stars" which will be used to provide illumination in deep water (I'm...

All rights reserved

Uploaded on Mar 4, 2011

0 comments

The camera housing, under construction. When finished it will probably be a bit shorter than this. A...

All rights reserved

Uploaded on Mar 4, 2011

0 comments

The car reversing camera I'll be using (left) and the balun (right) which transforms the camera signal...

All rights reserved

Uploaded on Mar 4, 2011

0 comments

Lower half of the ROV, showing all four bilge pump thrusters and the tubing/fittings used to direct the...

All rights reserved

Uploaded on Mar 4, 2011

0 comments

Top view of the bilge pump mounted on the grid.

All rights reserved

Uploaded on Nov 4, 2010

0 comments

The bilge pump on the mounting grid, held on with bolts and large washers.

All rights reserved

Uploaded on Nov 4, 2010

0 comments

Close up view of the top of the pump showing some details.

All rights reserved

Uploaded on Nov 4, 2010

0 comments

The very cheap 450 GPH bilge pump I bought for testing.

All rights reserved

Uploaded on Nov 4, 2010

0 comments

The assembled body.

All rights reserved

Uploaded on Nov 4, 2010

0 comments

The assembled body, with bouyancy pods held to top of frame with cable ties.

All rights reserved

Uploaded on Nov 4, 2010

0 comments

The bouyancy pods, painted. This photo was taken mainly to show off my dreadful paint job on the left pod.

All rights reserved

Uploaded on Nov 4, 2010

0 comments

These are drainage holes on the underside of the long side beams on the top and bottom parts of the...

All rights reserved

Uploaded on Nov 4, 2010

0 comments

Before painting the parts, I drilled these holes through the 90 degree elbow on the bottom part of the...

All rights reserved

Uploaded on Nov 4, 2010

0 comments

The painted mounting grid attached to the bottom part of the frame using cable ties. Very happy about...

All rights reserved

Uploaded on Nov 4, 2010

0 comments

Painting the components. The orange isn't really as bright as I'd hoped for, and in low/artificial...

All rights reserved

Uploaded on Nov 4, 2010

0 comments

The mounting grid which I sawed out of the breadcrate.

All rights reserved

Uploaded on Nov 4, 2010

0 comments

A breadcrate that I sawed up to get the grid for mounting components on.

All rights reserved

Uploaded on Nov 4, 2010

0 comments

A pre-paint mockup of the entire body.

All rights reserved

Uploaded on Nov 4, 2010

0 comments