|
geisemann's photostream |
|
Screw installed
Silicone placed over screw to protect seal and keep the silicone from leaking.
All rights reserved
Uploaded on May 9, 2005
Filling CRT
Adding Coolant using a small pin used for air filing rafts balls etc. Hook to a pump and it will fill and allow air to escape at the same time.
All rights reserved
Uploaded on May 9, 2005
8 Inch CRT Alligment
8 inch CRTS have to be very carefully assembled. There are 4 alligment tabs as showen here. You...
All rights reserved
Uploaded on May 9, 2005
8 inch CRT alligment
Put a o-ring around the crt and place in the housing. The o-ring will act like a spacer and keep...
All rights reserved
Uploaded on May 9, 2005
Digging out Silicone
8 Inch Rebuilding
Chip away access port and remove screw and remove coolant
All rights reserved
Uploaded on May 9, 2005
Adding Coolant
Replace the Static return and fill with coolant using a pump.
All rights reserved
Uploaded on May 9, 2005
Sealing the New Crt
Sealing the New Crt. Crts can be purchased sometimes in Bulk at a cheaper price and you have to mount...
All rights reserved
Uploaded on May 9, 2005
Silicone Sealant
Alligment
Put in new spacers to ensure the Crt sits flat and in focus range of lens. If you skip this step focus will be off.
All rights reserved
Uploaded on May 9, 2005
Clean & Inspect C-element
Remove C-Element and clean replace if scratched. Use a micro-fibre cloth to polish and remove any defects.
All rights reserved
Uploaded on May 9, 2005
Cleaning Housing
Cleaning the Housing and scraping it clean. Use water to wash it out and compressed air to try it .
All rights reserved
Uploaded on May 9, 2005
Removing Housing
Removing the Silicone with a knife. This takes time and a lot of force.
All rights reserved
Uploaded on May 9, 2005
CRT Rebuilding (click on...
