|
MakerGear's photostream
|
|
Extruder Mount
Insert the motor through the extruder mount (the C clamp) before attaching the filament drive. Two...
Some rights reserved
Uploaded on Oct 1, 2011
Extruder Mounted and Wired
Connect the heater and thermistor to the corresponding connectors. Connect the fan to the connector...
Some rights reserved
Uploaded on Oct 1, 2011
Extruder Mounted
If you remove the hot-end (black parts) from the filament drive (white) be sure to insert it all the...
Some rights reserved
Uploaded on Oct 1, 2011
Filament Drive and Hot-End
The filament drive is the white plastic part. When the hot-end is mounted on the filament drive, the...
Some rights reserved
Uploaded on Oct 1, 2011
MakerGear-Mosaic-Ramps1.4
The polarity for the Extruder Heater, HBP Heater and thermistors does not matter. The polarity for the...
Some rights reserved
Uploaded on Sep 30, 2011
HBP Mounted
The lower build platform (below the green heater pcb) is connected to the mounting plate using M4x14...
Some rights reserved
Uploaded on Sep 30, 2011
HBP Build Platform
Attach the removable build surface using the binder clips.
Some rights reserved
Uploaded on Sep 30, 2011
HBP Leveling platform
Attach the leveling platform as shown. The wiring for the heater PCB fits into the slot.
Some rights reserved
Uploaded on Sep 30, 2011
Z axis 4
Put the Z endstop on the shaft, as shown, then place a coupler above it. Put a coupler on the other shaft.
Some rights reserved
Uploaded on Sep 20, 2011
Extruder (Filament Drive...
Electronics
Mosaic HBP (heated build...
Mosaic Z Axis
Mosaic X Axis
Mosaic Y Axis
Mosaic Frame
Modular/Portabl e 3D Printer
PLA Glasstruder
Heated Build Platform...
» More Sets
