|
ptdecker's photostream |
|
Enigma-E Kit
A build of the Enigma-E--an emulator for the WW2 German Enigma machines. Built for John Lumley. This...
All rights reserved
Uploaded on Jan 24, 2011
Enigma-E Kit
A build of the Enigma-E--an emulator for the WW2 German Enigma machines. Built for John Lumley. This...
All rights reserved
Uploaded on Jan 24, 2011
Enigma-E Kit
A build of the Enigma-E--an emulator for the WW2 German Enigma machines. Built for John Lumley. This...
All rights reserved
Uploaded on Jan 24, 2011
Completed Cutter
Here is the final result using a model train transformer as the power supply. I ended up burning this...
All rights reserved
Uploaded on Dec 27, 2010
Wire Mounting System
To insulate the wire itself, I used a nylon washer both top and bottom. I also included a spring to...
All rights reserved
Uploaded on Dec 27, 2010
Frame Installed Using C-Clamps
I used simple c-clamps to hold the frame in place with a wooden block on the inside to protect my router...
All rights reserved
Uploaded on Dec 27, 2010
Mounting Block Detail (Rear)
A rear-side view of teh blcok with its cut channel. The block I used was actually scrap from a prior...
All rights reserved
Uploaded on Dec 27, 2010
Mounting Block Detail (Front)
A close-up view of the mounting block. I routed a channel for the bracket in the back of the block to help increase the stability.
All rights reserved
Uploaded on Dec 27, 2010
Aluminum Frame
Here is the U-frame made from light aluminum channel and L-brackets. It is fairly stiff but could be...
All rights reserved
Uploaded on Dec 27, 2010
Installed in Router Table
I used painters masking tape to tweak the height of the custom plate so that it is flush with the table surface.
All rights reserved
Uploaded on Dec 27, 2010
Homemade Router Plate
Homemade router table insert. Made using my routher with a 0.5" straight trim bit and my existing router plate as a template.
All rights reserved
Uploaded on Dec 27, 2010
1802 Membership Card Processor Board
This is the lower of the two boards that comprise the membership card. The RCA COSMAC 1802 processor is...
All rights reserved
Uploaded on Jul 25, 2010
1802 Membership Card Powered Up
Lee Hart's prototype of the 1802 Membership Card "retro-computing in a can" www.youtube.com/watch ?v=hbsPddZsmVI
All rights reserved
Uploaded on Jul 25, 2010
1802 Membership Card Front View
Here is a front view of the 1802 Membership Card retro-computing in an Altoid can. The...
All rights reserved
Uploaded on Jul 25, 2010
Modified Altoid Can for the 1802 Membership Card
Altoid can modified to hold the 1802 Membership Card. The lid was cut with a dremel tool then a card...
All rights reserved
Uploaded on Jul 25, 2010
1802 Membership Card I/O Board
This is the upper board of the two that comprise the membership card. It contains the input and control...
All rights reserved
Uploaded on Jul 25, 2010
IMG_0526
Atari Punk Console installed in a salvaged Parallel Printer Switch box from Blackbox with appropriate...
All rights reserved
Uploaded on Jul 9, 2010
Elf 2000 with homemade wooden case.
Inside view
Enigma-E
Nichrome Hot Wire Foam Cutter
Elf 2000
1802 Membership Card
Electronics Projects
