|
MaskedRetriever's photostream |
|
Nested Spheres
My bot isn't tuned up yet, so I get a lot of stringing. I think the spheres might still be...
Some rights reserved
Uploaded on Mar 17, 2011
Building a Speaker, Step 4
Finished winding. So far I haven't built a successful speaker, owing due to 1: not having...
Some rights reserved
Uploaded on Mar 17, 2011
Building a Speaker, Step 3
Continuing the winding around, there's only so many windings that'll fit. Pushing your...
Some rights reserved
Uploaded on Mar 17, 2011
Building a Speaker, Step 2
Next, windings. I haven't worked out the math (yes I know, for shame) of the coils so I don't...
Some rights reserved
Uploaded on Mar 17, 2011
Building a Speaker, Step 1
First, print the speaker. This is actually a fairly fun build to watch.
Some rights reserved
Uploaded on Mar 17, 2011
Second, better print!
The distortion on the raft is actually caused by my trying to lift it, still gooey, from...
Some rights reserved
Uploaded on Feb 28, 2011
First Hexagon
The raft came out looking like fuscilli, which is awesome. Second print had a much better raft.
Some rights reserved
Uploaded on Feb 28, 2011
First Raft, Video!
My X-endstop is not working properly for some reason, so I've disabled homing. As a result, my...
Some rights reserved
Uploaded on Feb 28, 2011
Oh noes it are backwards!
Put the back panel on reversed by mistake, resulting in the following comical power supply configuration. Will fix later.
Some rights reserved
Uploaded on Feb 28, 2011
Built!
Two days flat! I wasn't even working full time! The Thing-o-Matic is amazing! The last time I...
Some rights reserved
Uploaded on Feb 28, 2011
Leftovers!
I am so keeping that handy Screw and Bold reference chart. LOVE that.
Some rights reserved
Uploaded on Feb 28, 2011
JB Weld Fractals
JB Weld was my most-readily available epoxy and it went on the extruder plates Saturday night,...
Some rights reserved
Uploaded on Feb 28, 2011
Photo of Rod Stop Placement
I want to upload this to the Wiki to replace the error in the photo there...
Some rights reserved
Uploaded on Feb 28, 2011
A Workin' Hand
Build the stepper extruder module and XY carriage straight in one go and you'll notice...
Some rights reserved
Uploaded on Feb 28, 2011
For Old Time's Sake
Hey, I liked the frame-of-me photo before, I like it now.
Some rights reserved
Uploaded on Feb 28, 2011
Lasercut Parts Unpacking
I LOVE the new red-and-black printing on the cases. May have to nailopolish over it or something to add pizzaz later, but for now, awesome.
Some rights reserved
Uploaded on Feb 28, 2011
Thing-o-Matic Build
Hercules On v2 Hardware
Printable Gearbox
The MakerBot Pen Plotter
3D Prints
Makerbot Build
