|
GL5Keith1500's photostream |
|
1500
Machine a piece that will make upto 5 dies for the expansion links. that allows one mistake!
All rights reserved
Uploaded on Sep 30, 2011
1500
General assemble of the expansion link. Note the hollow dowel pins that hold the tail pin to the...
All rights reserved
Uploaded on Sep 30, 2011
1500
General assemble of the expansion link frames that sit on the 1500. The 1500 is quite a clever...
All rights reserved
Uploaded on Sep 30, 2011
1500
LMS Milk Tank
The box coming together with a piece placed on top to show the general fit of the box.
All rights reserved
Uploaded on Feb 11, 2011
LMS Milk Tank
The base and door made and the sides and end cut ready for the next stage.
All rights reserved
Uploaded on Feb 11, 2011
1500
Could nt resist adding a bit more detail to the loco. So i have added a pipe which pops out of th...
All rights reserved
Uploaded on Feb 6, 2011
LMS Milk Tank
The access lid being fitted in place using some P38 body filler. A small round head screw has been...
All rights reserved
Uploaded on Feb 6, 2011
LMS Milk Tank
Out-shopped. The Tank wagon joins the others. In order of making. 2003/4 Toad. 2004 Cable drum. 2005 Somerset. 2011 Milk tank.
All rights reserved
Uploaded on Feb 6, 2011
LMS Milk Tank
pining over part of the weights stem in to the screw. Note this needs to be able to rotate.
All rights reserved
Uploaded on Feb 6, 2011
LMS Milk Tank
Setting the weight the right distance from the pivot point. Note the surplus steam is cut off...
All rights reserved
Uploaded on Feb 6, 2011
LMS Milk Tank
The component parts of the weight. Note the stem of the weight is piano wire for strength.
All rights reserved
Uploaded on Feb 6, 2011
LMS Milk Tank
The weight having a flat applied to either side. Note the stem was left long so it is held in the...
All rights reserved
Uploaded on Feb 6, 2011
LMS Milk Tank
The cross pieces having been drill and then back in the lathe to have a 7.5 degree taper put on...
All rights reserved
Uploaded on Feb 6, 2011
LMS Milk Tank
The cross piece having had two flat milled on either side. This is the start of putting in a 2BA tapped hole.
All rights reserved
Uploaded on Feb 6, 2011
