new icn messageflickr-free-ic3d pan white
Finished Breadbox - DSC_9602 | by Dylan Parker
Back to photostream

Finished Breadbox - DSC_9602

The final product installed and functional.

 

I decided to go with simpler stencil for the front panel rather than the elaborate design on the original.

 

The bread box is raised in the air about 0.25" by clear rubber feet to allow airflow to enter the air intake just behind the closed panel.

 

I tried to only modify the bottom and back of the bread box but had to put the single screw through the top to help support the PSU from potentially slumping onto the motherboard.

 

I replaced the internal door latch by embedding 3 tiny neodymium magnets into the edge of the bread box door which gives just enough snap while still being easy to open.

1,668 views
0 faves
0 comments
Taken on June 12, 2010