|
angusforsyth's photostream |
|
bailer first gasket
sealant might not be needed if fitting to a smooth plastic hull but I was taking no chances with the...
All rights reserved
Uploaded on Dec 3, 2011
bailer dremel
bailer hole cut
Removal of 1976 bailer left a hole that was too short for the new replacement. This picture shows...
All rights reserved
Uploaded on Dec 3, 2011
finished 24SEP11
Finally got everything screwed together. Launched on Sat 24th Sept 2011 and rowed up and down the Almond river..... ...next project please...:-)
All rights reserved
Uploaded on Sep 25, 2011
140911 paint finished
Missed the CBC regatta deadline but needed to get another coat on the deck. Now it's fitting out and...
All rights reserved
Uploaded on Sep 14, 2011
centreboard 060911
topside prekote 060911
will it be ready for the weekend? time is running out !!
All rights reserved
Uploaded on Sep 6, 2011
topside sanding 010911
Driving the neighbours daft with the noise of the belt sander again...
All rights reserved
Uploaded on Sep 6, 2011
solo 190811 stern primed
solo 190811 bow primed
First coat of primer took about 20 minutes with a roller - looooverly finish...:-)
All rights reserved
Uploaded on Aug 19, 2011
solo 180811 stern
The biggest of the holes in the hull is now repaired and watertight.
All rights reserved
Uploaded on Aug 19, 2011
solo 180811 stbd bow
All four holes in the hull are now repaired, the cracks in the transom glued together, the rotton...
All rights reserved
Uploaded on Aug 19, 2011
solo 180811 bow sanded
Full sanding and prep for filling, fairing and primer coat. Belt sander used on the flat bits, disc...
All rights reserved
Uploaded on Aug 19, 2011
solo 180811 bow half sanded
Start of the sanding removing all loose paint and any imperfections.
All rights reserved
Uploaded on Aug 19, 2011
CBC drain overflow 8th July...
Solo 2911 Resurrection
Winter at Cramond
Fisherrow
