|
justaguy168's photostream |
|
optical drive label
Outside of the plextor optical drive showing model number.
All rights reserved
Uploaded on Sep 6, 2011
power supply label
Outside of the 300 watt power supply showing the model number and specifications. I hade bought...
All rights reserved
Uploaded on Sep 6, 2011
power supply fan
mobo placement
Mobo installed but nothing else. Notice penny for scale. Yes, I remembered to remove the penny.
All rights reserved
Uploaded on Sep 6, 2011
psu mobo clearance
Shows about 2 1/2 inches between top of rear panel and bottom of power supply.
All rights reserved
Uploaded on Sep 6, 2011
psu case fan clearance
Shows only 2 inches between back of psu and front of fan. the psu cables have to be threaded in this space!
All rights reserved
Uploaded on Sep 6, 2011
usb cable fail
Could not run USB cables behind the drive up against the mobo. Probably not good for airflow anyway.
All rights reserved
Uploaded on Sep 6, 2011
initial power + usb cables
Some power and usb cables connected. Will run on this side of psu.
All rights reserved
Uploaded on Sep 6, 2011
24 pin atx header
power cable wraparound
It was tight, but was able to wrap cable around outside of fan (mostly). Hope airflow will be sufficient.
All rights reserved
Uploaded on Sep 6, 2011
power cable wraparound 2
Shows that most of the fan is cleared of the cable, Sorry about the light, it was tough to get a good picture.
All rights reserved
Uploaded on Sep 6, 2011
final cable runs
The cable runs I decided on. Cover is ready to be screwed on. Uncertain whether I should sleeve...
All rights reserved
Uploaded on Sep 6, 2011
Airflow Lian Li Q11
I drew this diagram in MS Word of the overall airflow patterns. The case fan sucks air in from the...
All rights reserved
Uploaded on Sep 6, 2011
cover on
Lian Li requires 8 of the tiniest phillips screws to put on this cover. Not only that, for a deluxe...
All rights reserved
Uploaded on Sep 6, 2011
rear end
Shows back of case. Decided not to run usb 3.0 cables from front of case through back gromment. Want front usb ports to be 2.0.
All rights reserved
Uploaded on Sep 6, 2011
rear end detail
initial bios boot screen
memory test
Ran Memtest probably not as long as some, but longer than others. Checked ok.
All rights reserved
Uploaded on Sep 6, 2011
finished product
The (mostly) finished product. Still need to tidy up my cables.
All rights reserved
Uploaded on Sep 6, 2011
ITX Desktop Build
