|
jcm_flickr's photostream |
|
iButton Data Logger Programmer Prototype Up and Running!
iButton data logger programmer prototype is finished! Next step is to clean up the code and create...
All rights reserved
Uploaded on Nov 22, 2008
Sanguino 1Wire iButton Datalogger Programmer Prototype
Upgraded from Arduino Decimila to Sanguino with Atmel atmega644P processor with 64k flash memory. I...
All rights reserved
Uploaded on Aug 17, 2008
DS1994 Clock is Working with Arduino!
DS1994 Clock up and running! Using Arduino 1 Wire Library to read 4 (1) byte clock registers which...
All rights reserved
Uploaded on Jul 6, 2008
DS1994_ClockTestSec
DS1994 iButton Real Time Clock hooked up to Arduino using RJ11 connector and 1-wire...
All rights reserved
Uploaded on Jul 1, 2008
Arduino_DS18S20_Temp_LCD
Arduino and protoshield with DS18S20 temperature sensor using 1-Wire bus and library. Interfaced with Newhaven I2C LCD.
All rights reserved
Uploaded on Jun 17, 2008
I2C_LCD_ArdunioCountTest
Newhaven NHD-0216K3Z-FL-GBW 2 row x 16 LCD up and running on an Arduino in I2C mode. (Only two...
All rights reserved
Uploaded on Jun 15, 2008
LCD_I2C_enable_jumper_R1
Jumper wire soldered onto R1 pad to enable I2C mode for the Newhaven LCD display. I ended up using a...
All rights reserved
Uploaded on Jun 15, 2008
LCD_I2C_Jumper_loc
Location of R1 pads for I2C jumper for Newhaven LCD display as described in the LCD manual
All rights reserved
Uploaded on Jun 15, 2008
LCD_I2C_HookupArduino
Using I2C mode, pins 3, 4, 5, 6 are required as shown. LCD Pin 3 goes to Arduino analog in pin...
All rights reserved
Uploaded on Jun 15, 2008
IR LEDs added to safety glasses for HT
Took Johnny Lee's idea of using safety glasses for Wii Head Tracking. Added Radio Shack 1.2V (1.6V...
All rights reserved
Uploaded on Jun 8, 2008
Arduino_HelloWorld
Classic microcontroller "Hello World" with Red LED and resistor on Arduino Protoshield....
All rights reserved
Uploaded on Jun 8, 2008
A_protoshield1
Assembled Arduino Protoshield without breadboard attached from www.adafruit.com. Helped improve my soldering skills!
All rights reserved
Uploaded on Jun 8, 2008
Used string to pull in assembly
Grab the switch with a pair of needle nose pliers and pull up. Then screw nut around switch. I had...
All rights reserved
Uploaded on Jun 6, 2008
Arduino
Wii Light Pen & Head...
Traxxas Slash
