|
LogicalZero's photostream |
|
GAMBY Prototype #2
The second batch of prototype boards for my LCD game shield. This round was manufactured by Laen of the Portland chapter of Dorkbot.
All rights reserved
Uploaded on Sep 10, 2011
GAMBY Prototype #1
The first assembled, working prototype of my Arduino LCD/game shield, GAMBY.
Some rights reserved
Uploaded on Nov 15, 2010
BBB with little LCD
Soda Machine Selection Decoder, schematic
The board that connects the selection detection interface to the TINI board. The board is designed...
All rights reserved
Uploaded on Oct 19, 2009
Soda Machine Selection Decoder, board layout
The board that connects the selection detection interface to the TINI board. The board is designed...
All rights reserved
Uploaded on Oct 19, 2009
Servo Holders v2.0 in SketchUp
A slight resdesign of the pan/tilt servo motor mounts, as seen in SketchUp. The base (right) has...
Some rights reserved
Uploaded on Oct 6, 2009
Servo Holders v2.0, fabricated
The physical manifestation of the servo motor mounts, this time in white ABS, after some clean-up with a razor knife.
Some rights reserved
Uploaded on Oct 6, 2009
Servo Holders v2.0, assembled
The assembled pan/tilt rig. Tweaks to the print settings made them a little more accurate, so at 10%...
Some rights reserved
Uploaded on Oct 6, 2009
Servo Holders in SketchUp
My first venture into the wild world of desktop fabrication. These are holders for a pair of tiny...
Some rights reserved
Uploaded on Oct 2, 2009
Servo holders, fabbed
My first venture into the wild world of desktop fabrication. These are holders for a pair of tiny...
Some rights reserved
Uploaded on Oct 2, 2009
More additions to TGIMBOEJ "Gray-K"
After seeing some of the photos of other TGIMBOEJes, I thought Gray-K needed some...
Some rights reserved
Uploaded on Sep 22, 2009
My additions to TGIMBOEJ "Gray-K"
The stuff I put into the "Gray-K" Internet migratory box of electronic junk. There might...
Some rights reserved
Uploaded on Sep 17, 2009
Vending Machine, interior
The inside of the vending machine's front panel. All of the electronics (except the refrigerator and...
Some rights reserved
Uploaded on Sep 17, 2009
|
Map
Vending Machine, exterior
The soda machine. It looks like something from which someone would buy an RC Cola while on break from their console at Apollo Mission Control.
Some rights reserved
Uploaded on Sep 17, 2009
|
Map
Vending Machine, interior (detail)
A close-up of the pertinent parts of the machine's workings.
Some rights reserved
Uploaded on Sep 17, 2009
|
Map
Selection Detection schematic
The schematic of the board designed to detect presses of the soda machine's selection buttons. This...
Some rights reserved
Uploaded on Sep 2, 2009
Relay Board schematic
The schematic of the basic relay board designed to let a microcontroller add credit to the soda...
Some rights reserved
Uploaded on Sep 2, 2009
Soda Machine schematic
The schematic of Willoughby & Baltic's vintage beverage vending machine. The...
Some rights reserved
Uploaded on Sep 2, 2009
|
Map
